Motorcycle Turn Signals Wont Flash

Get a multimeter and check at the flasher to see that youre getting proper volts 12V at least.

Motorcycle turn signals wont flash. If its getting enough then replace the relay. If the relay isnt getting enough voltage it wont work. Turn ignition switch to IGN.

It thinks all your bulbs are burned out due to the low current draw. Now in the dash area both turn signal indicators come on at the same time. Might be you have to replace some relays but on that bike they should be super cheap.

Looked in the service manual and this problem is not listed for troubleshooting the turn signals. Based on my knowledge in the automotive world. If bike is moving if you press the right turn signal it will light up but not flash.

Step 5 TSSM reading and resetting trouble codes Turn the ignition to runstop in run position with ignition off. Theory 1 LED turn signal installation of the front or rear only while using bulb lights at the opposite end front or rear does not require flash controllersresistors. 6v LED turn signal doesnt flash FINALLY SOLVED.

I spent way too long on this. Theory 3 A flash controllerresistor is necessary for every LED turn signal or light that is installed. NTHREEAUTO 3 Pins LED Flasher Relay Fix for Motorcycle Turn Signal Hyper Flash Compatible with Scooter Moped ATV Dirt Bike Blinker Relays.

Background should light up speedometer needle should sweep its full range and indicator. The original relay did not operate with the low draw from the new indicators. Try it without one turn signal and see what happens When I removed the front signal and hit the switch the rear turn signal came on though it didnt flash.