Motorcycle Throttle Cable Adjustment

Fine-tuning can take place with the adjuster by the grip.

Motorcycle throttle cable adjustment. Adjust the deceleration bottom cable until you remove the play almost completely. Install the opposite ends of the throttle cables to the carburetor or throttle body tightening the threaded ends of the cable guides into the cable bracket completely. Tighten Loose Throttle Cable Adjustment - MotorcycleTighten Loose throttle Adjustment - MotorcycleTighten Loose Accelerator Adjustment - MotorcycleFix loose.

The cable adjuster can then be adjusted in or out so that the throttle grip has the correct amount of free play which is usually 2-3mm. Removing and installing the 5 and later clutch cable. Then adjust most of the slack out of the decel push cable.

Just like an old 1 cable throttle. If it has two cables one handles the opening of the throttle and the other handles the return. Smaller changes can be made at the barrel adjuster on your throttle cable.

Dont just deal with your sluggish throttle. Adjust the decel cable too tight too little slack and the throttle will. Over time cables stretch and will need adjusting to reduce the amount of free play on the throttle.

The lower cable adjustment involves loosening the cables lock nut making the change to the adjustment nut tightening the lock nut back in position and rechecking the throttle free play. For minor free-play adjustments use the inline. Adjust the pull cable so theres just a little slack.

Slide the cables barrels into the valve catches and twist the throttle tube slightly to check that the valves open and close properly. At this point if you try to accelerate there is a lot of play before the throttles open. Your motorcycle will either have one or two throttle cables.