Motorcycle Starter Solenoid

So now the question is why arent you getting the start signal when you turn the key or hit the starter switch.

Motorcycle starter solenoid. A starter solenoid is a combination of solenoid and switches Full name. Basics The wire supplying amounts of electricity to the starter motor is thick therefore a special switch is needed to allow the power to be turned on and off. While a problem with starting the engine may be as a result of it being damaged its not always the case and learning how to diagnose a faulty one is important.

The solenoid plays the role of an electric relay that closes the starter circuit and feeds the motor with electricity when you turn the ignition key to the start position. Remove the starter and inspect the drive gear for damage that could indicate a misalignment with the ring gear and replace. If the battery is strong enough to light the headlight with its usual brightness and nothing no click or thunk happens then check that the starter button sends a signal 12 volts to the small wire on the solenoid.

Standard Motorcycle Products Standard Chrome Starter Solenoid. Bench-test the starter by briefly connecting it to a12-volt power supply while firmly holding the starter down on a bench. If the solenoid is good the next thing to check is the starter itself.

For motorcycles electric starters began to replace the old-fashioned kickstart during the 1960s. The solenoid also moves forward the starter gear also known as Bendix so that it comes in contact with the flywheel teeth. When you short it with the wrench youre simulating a start signal on the small terminal.

When the starter button is pressed it energizes the coil which pushes a contactor to complete the circuit. The starter solenoid is just one of the components of a starter system. Shop the best Motorcycle Starter Solenoid Components for your motorcycle at JP Cycles.

Bypass the starter relay Simply put to overcome and bypass a faulty starter relay or ignition switch you can touch both the positive starter terminal and the solenoid terminal on the starter using a big screwdriver. When you do that the solenoid does its job so the solenoid is probably good. This transfers DC current from the battery to the starter.