How To Replace A Starter On A Motorcycle

Push the starter button and read the volt meter.

How to replace a starter on a motorcycle. Remove all three bolts that secure the starter to the motor using the 10 mm socket. The battery terminal is labeled with a B and the starter motor terminal is labeled with an M The electricity should flow with continuity through the whole circuit when the battery is connected. Starters also have fuses which need to be checked.

Theres 2 allen bolts holding the starter in. If the meter reads less than one volt the solenoid is good and you will need a starter as long as the connections are good and tight. Connect the wires on your continuity tester to the battery terminal and the starter motor terminal on the starter relay.

Step 2 Unhook the wiring harness and use the crescent wrenches to remove the mounting bolts and slide the starter out of its perch. Locate the wires running from the start switch on the handlebar down to the solenoid and starter. Remove the starter motor from the motorcycle.

Pop the old one out new one in. Slide the starter out of the block until it. You can see how to replace the starter clutch on the videoFOLLOW OUR ON INSTAGRAM https.

Take the starter to a Harley technician. If these fuses blow no electricity an flow to starter so check the fuses. NIKAVI Self Starter Motor Assembly Compatible for Honda UnicornHonda Shinehttpsamznto2Ve6E9EHow to Replace Starter Motor in Motorcycleselfrepairguruji.

New starter with a 1 year warranty. If the engine cknocks when starting the starter clutch is poor. Slide the new starter into place and mount it tightly by tightening the bolts back down with the crescent wrenches.